What have you done to your 5th Gen 4Runner today?

I attempted (the key word being attempted) to install the TRD skid plate from Cartrimhome this afternoon. It looked easy enough, even to me and I am not at all mechanically inclined although I have gotten better over the last few years.

I got the old skid plate off with no problem. I held the new skid plate up and I could tell something wasn’t right. I then remembered reading something about having to remove the radiator support brackets so I did that. Held the skid plate back up and something still wasn’t right. The bolts for the rear were not long enough. I then figured out that because of the lift kit and the front differential drop, I would have to have longer bolts and additional spacers. Off to Home Depot. I was able to eventually come up with bolts and hardware to make additional spacers. By the time I got back home, it was dark outside. So, I will try again tomorrow.

 

Does the new skid support the radiator? Otherwise I would question removing the support brackets

 

There still appears to be more than sufficient support for the radiator. I called them “radiator support brackets” because that’s what they were called in what I read somewhere. I don’t know if that is actually the correct term for them. Either way, the radiator isn’t going to move. Plus with the new skid plate in place, the radiator is well protected in the bottom side.

 

U have a link? How does it install? Thanks

 

TRD skid plate install is complete. I went with the Cartrimhome version since I have KDSS. It was a PITA because there were no instructions and the YouTube videos I watched left out a lot of important details but I got it done.

 

Looks good! I need to get black letters for mine.

 

$63 powoq Backrest Mat Compatible with 2010-2024 Toyota 4Runner Back Seat Protector TPE Mat Replacement for 2010-2024 Toyota 4Runner 5-Seat Accessories (Fit W/and W/O Sliding Tray, Rear Backrest Mats)

https://www.amazon.com/dp/B0BFQVXHSD/?coliid=I384Y38VJJ6PCL&colid=3NMPIIX2NX38F

I haven’t pulled the trigger yet but I think they Velcro to the seat backs.

 

Yeah, they use Velcro. If you actually use the cargo area for.....cargo, these are a must. I tore my Canvasbacks while camping. Not a knock on the CB's, they do their job. But are not designed for hard use.

 

Replaced the lower valence that's been waiting on me for a minute. Full storm trooper now. Also found out I had some scratches that have appeared on the rear bumper that I'll try buffing out and a crappy repair on the edge of the bumper I had never noticed before. None are a big deal but definitely annoying.

 

My wife has these in her Outback. I just pulled them out an hour ago because she needed the slippery carpet to move some heavy objects. Besides velcro, hers had some elastic cords that looped over the back seat headrests.

 

Just installed RSG Metalworks rock sliders. Took about an hour and 45 mins. About 23-25 bolts than need to be screwed in but definitely worth the investment.

 

Workin' on cheeky gear shifter squeak

https://youtube.com/watch?v=q34h9lqlqYE&feature=share9

 

I think I’ve used the term radiator support brackets because I read that too (LOL), but they seem to actually be additional bracing for the stock skid plate. Since this skid plate is tougher than stock it should be fine , unless you may come crashing down on a rock when off road.

 

Installed Rotopax deluxe mounting bracket on my Crestone window panel. 4 gallons is only good for a measely 75-80 kms for off road gas mileage.

When I get the rear swing out tire carrier, I’m definitely going to order the under carriage spare tire gas containers, since 2 of them would fit perfectly for ground clearance and would be an added 12 gallons.

 

Hey Vito, What Pro grill is that? Cover or OEM?

 

The grill is also from Cartrimhome. It is o.k. but still not OEM quality regardless of what the YouTubers say.

 

Thanks.
Like your skid.

 

Who else only gets to work on the Runner during baby sleeping hours

 

I added 24 gallons with a Long Range America auxiliary gas tank. 47 gallons on board total. If you reposition your spare you have cleared where the LRA will sit. Just saying.

 

my kdss friends know

[nice torque cheatsheet]
https://trail4runner.com/2020/06/17/5th-gen-4runner-torque-specs/

 

I got mine from eBay. Not an Amazon guy.

https://www.ebay.com/itm/394523710875

 

A little black out bling valence and fang extender. (Drivers only in the pic)

 

Did you replace the front valance, paint, or Plasti-Dip? Looks good!

 

My 4Runner hit 30,000 miles today. It happened as I was driving home, right before getting home. I pulled into my driveway, listening to the awesome cock rock band Big Cock, eager to take a photo of my 30,000 mile accomplishment. This is over 1/3 of the distance my old Jeep went! After I took the photo, Akio Toyoda remoted into my 4Runner via its Big Brother Toyota Telemetry System and pleasured me like he never pleasured me before. I'm serious. The sounds that were coming out of my 4Runner, the way my 4Runner shook, my neighbors next door were staring at me in shock as I stepped out of my 4Runner after Akio Toyoda's ravenous pleasure session. I assured my neighbors that everything was fine and then walked away bow-legged and satisfied. I might buy another Toyota just to feel this way at 30,000 miles again. Thank you, Akio Toyoda.

 

4runner lifestyle makes them in black. Swap it out. Little PIA but not too bad

 

I gave you pics Even pics of Big Cock The rest of it is private

 

Spray paint the valance

 

Transported a 12 lb brisket home last night and smoked the shit out of it!! Yummy!

 

Found a great deal on some oem sliders on OfferUp that I couldn’t pass up until I buy a different set with kickers