Where's the fuse box? Wiring in a dashcam?

I have a new (to me) 2023 4Runner SR5, and I also have a Blackvue front/back camera setup. I'd like to hardwire them into my T4R, but I don't know how. Can anyone point me to YouTube or similar knowledge that might get me started? I know how to run wire, etc, except for the part where I get to the wire-in point. Any pointers would be much appreciated.

 

Driver kick panel where it has been since 2010. I'm not sure what fuse to pull power from since I pulled from aftermarket stereo wiring.

 

Hey OP
I wish you good luck, but I gotta say if you don’t know where your fuse box is and you don’t know how to find that information in your manual or on Google or YouTube; I’m not so sure you should be messing with your 2023 automotive wiring.

 

That being said everyone has to start somewhere and that was me 4 years ago.

May I suggest reading the following threads on 5th gen dash cams.
And probably find your manual too.

https://www.4runners.com/threads/front-rear-dashcam-wiring-question.38172/
https://www.4runners.com/threads/switched-circuit-for-dashcam-2023-trd-off-road-premium.34172/
https://www.4runners.com/threads/dashcam-which-fuse.31554/

 

Thank you for that. This was very helpful, informative, and saved me considerable time. I appreciate it.

 

Been brushing up on my YouTube-fu, and I think I'm ready to install the Blackvue camera system. Seems pretty straightforward thanks to the info here and a few install videos. Thanks again for all the input, I appreciate it.

 

Great to hear! Gotta love “YouTube University”.
Post more questions you have as you go, I’m sure the folks will help