1. Welcome to 4Runners.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all 4Runner discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other 4Runner owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Squeaky front suspension

Discussion in '5th Gen 4Runners (2010-2024)' started by Shredder, Jul 23, 2024.

  1. Jul 23, 2024 at 8:16 PM
    #1
    Shredder

    Shredder [OP] New Member

    Joined:
    May 5, 2024
    Member:
    #40266
    Messages:
    36
    Gender:
    Male
    I have a 2023 OR 4runner with about 12,000 miles and today on some kinda rough two track roads the front end developed a squeak when going over bumps or holes. Is it a common problem and is there anything i can do to quiet it?
     
  2. Jul 23, 2024 at 10:20 PM
    #2
    Rick G.

    Rick G. Member since July, 2020

    Joined:
    Jul 30, 2020
    Member:
    #15832
    Messages:
    133
    Gender:
    Male
    The Texas Hill Country
    Vehicle:
    2022 SR5 Premium 4WD
    A few weeks ago I developed a squeaking noise in the front of my 2022 SR5 Premium 4WD. I traced the squeak to the two adjustable rubber bump stops under the hood- one at each front corner of the engine compartment. You’ll see them when you have the hood open. They are adjustable by turning them clockwise or counter-clockwise. I spritzed the tops of both of those black rubber bump stops with some WD-40 and the squeaking noise stopped. This might be where your squeak is coming from. I also thought the noise was coming from my front suspension at first, before finding out otherwise. Other than WD-40, I suppose a couple dabs of white grease on the bump stops, or some silicone spray could also be used. Good luck.
     
    Guppy1301 and Shredder[OP] like this.
  3. Jul 23, 2024 at 10:33 PM
    #3
    Fortuner

    Fortuner New Member

    Joined:
    Jan 12, 2021
    Member:
    #19082
    Messages:
    168
    CA
    Vehicle:
    2021 4Runner TRD Off Road Premium w/KDSS
    If it’s not the hood adjusters or hood latch, check your engine splash guards.
     
  4. Jul 23, 2024 at 10:43 PM
    #4
    Slopemaster

    Slopemaster Slope Survivalist

    Joined:
    Mar 20, 2021
    Member:
    #20442
    Messages:
    3,018
    Gender:
    Male
    Idaho
    Vehicle:
    2018 SR5
    265-70-17 Ridge Grapplers, TRD Pro rims, 3M precut bra, N-Fab nerf/steps
    +1
     
  5. Jul 23, 2024 at 11:24 PM
    #5
    Gripster

    Gripster New Member

    Joined:
    Mar 3, 2023
    Member:
    #31544
    Messages:
    80
    Gender:
    Male
    Vehicle:
    2016 Trail Premium
    Splash guards is my vote.
     
  6. Jul 24, 2024 at 6:20 AM
    #6
    Shredder

    Shredder [OP] New Member

    Joined:
    May 5, 2024
    Member:
    #40266
    Messages:
    36
    Gender:
    Male
    Last edited: Jul 24, 2024
  7. Jul 24, 2024 at 7:55 AM
    #7
    Fortuner

    Fortuner New Member

    Joined:
    Jan 12, 2021
    Member:
    #19082
    Messages:
    168
    CA
    Vehicle:
    2021 4Runner TRD Off Road Premium w/KDSS
    I ended up replacing mine with aftermarket ones to avoid the noise. To diagnose it, I placed electric tape on them and drove around on a route I knew would make the noise…with the tape, the noise stopped. I ordered replacements from a place called “rad rubber designs”
     
    Shredder[QUOTED][OP] likes this.
  8. Jul 24, 2024 at 9:58 AM
    #8
    Shredder

    Shredder [OP] New Member

    Joined:
    May 5, 2024
    Member:
    #40266
    Messages:
    36
    Gender:
    Male
    I went to a self serve car wash and was able to get a ton of dirt out of the wheel wells. Now I don’t hear the squeak.

    The looks like plastic screws holding the splash guard, are those like thumb screws? Is there a nut or a threaded hole behind the guard?
     
  9. Jul 24, 2024 at 10:43 AM
    #9
    nimby

    nimby in the drink

    Joined:
    Mar 27, 2017
    Member:
    #3777
    Messages:
    4,588
    First Name:
    Jake
    California
    Vehicle:
    2018 SR5P
    It's just a clip.

    I think the part number is 90467-10186 (if I'm not mistaken).
     
    Shredder[QUOTED][OP] likes this.

Products Discussed in

To Top