1. Welcome to 4Runners.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all 4Runner discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other 4Runner owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Roll Bar Dimensions

Discussion in '1st Gen 4Runners (1984-1989)' started by holvey, Jul 12, 2023.

  1. Jul 12, 2023 at 4:10 PM
    #1
    holvey

    #1
    holvey [OP] New Member

    Joined:
    Jul 12, 2023
    Member:
    #33894
    Messages:
    1
    First Name:
    Brian
    Hi, I'm Brian from Portland, OR, and I am hoping to buy a 1st gen over the next couple of months. I have a question that seams to be hard to track down without actually owning one. I am looking for the width of the cargo area at the narrowest point above the wheel wells. I'm not sure from photos whether it is narrower at the inner lip of the tailgate or if it is the roll bar.

    The reason is I have to transport full sheets of plywood sometimes and would love for them to go in the cargo area instead of on the roof. I'm not concerned with the length, as my short bed Tacoma does it just fine hanging out the back. Thanks!
     
    holvey, Jul 12, 2023
    #1
  2. Jul 13, 2023 at 12:51 PM
    #2
    se7enine

    #2
    se7enine New Member

    Joined:
    Dec 11, 2019
    Member:
    #12287
    Messages:
    135
    Gender:
    Male
    Vehicle:
    1984 4Runner
    3RZ
    It's around 46" in between the roll bar so you won't fit a sheet in flat but can fit a couple at an angle.
     
    se7enine, Jul 13, 2023
    #2
Register FREE to Reply!
To Top