PRO Roof Rack Wind Deflector

I'm happy with my Pro roof rack but I think a front wind deflector would be good for appearance and gas milage. Has anyone made one or know of any source?

 

I was wondering the same with these Pro racks but haven’t seen anything, guess will just have to get a Prinsu or Sherpa!

 

Not specific to Pro but a source for custom fairing.

https://trail4runner.com/2021/06/02/colorado-fairing-company-custom-wind-fairing-5th-gen-4runner/

 

Thanks, that's kind of what I wanted to know about.

 

Did you find a wind deflctor? I have been looking all over and have had no luck.

 

Yes,
I bought it from a fellow forum member who had pieced it together for his Pro, then changed his entire roof rack. It has "Matterhorn" laser cut on the fairing so I assume it is a Sherpa. I'm not sure about the brackets. They have no mfg name on them but they look pretty simple. I have not yet attached the center bracket, I'm waiting on delivery of some stainless screws.
I did it just for looks as I have yet to use the rack. Maybe it could reduce the wind drag of the rack.

 

Yeah, had a brain fart, I talked to you before about it. I think it looks awful, you should take it off. I'll get rid of it for you.

 

Looks to be simple column clamps with chamfered corners. I suspect the crossbrace to be either bar stock or L-channel attached to the clamps.

 

The clamps for the fairing ends look just like the metal clamps with those rubber inserts shown in this Amazon picture.
https://www.amazon.com/2-Pack-Quick-Release-Rubber-Mounting-Brackets/dp/B0D1R68J1M/?_encoding=UTF8&pd_rd_w=Ym5Nq&content-id=amzn1.sym.255b3518-6e7f-495c-8611-30a58648072e%3Aamzn1.symc.a68f4ca3-28dc-4388-a2cf-24672c480d8f&pf_rd_p=255b3518-6e7f-495c-8611-30a58648072e&pf_rd_r=9P5AKNW95BPJG89W2S1V&pd_rd_wg=TCzpA&pd_rd_r=f2a793f0-d34e-4061-ac82-50545d044fa0

They only attach to the fairing with one screw each side. The other hole in the fairing end is filled with a "dummy" screw.
Here's another photo of the install:

 

I was close, that dummy screw fooled me! Column Clamp with a mounting 'wing'....a pair would be less than a dollar job on my printer!