Ironman 4x4 Foam cell pro Lift Kit

https://ironman4x4america.com/foam-cell-pro-suspension-kit-suited-for-toyota-4runner-2010-stage-3/
Anyone running Ironman 4x4
Foam Cell Pro Lift Kit on their 5th generation SR5 4 Runner? No KDSS.
Or Have experience/familiar with the company-gear??
Looking at a (stage 3) 2.5-3” lift...
This is my daily driver, mostly highway, weekend trail, overland/ camping, towing boat/camper (4000lb)
Trying to dial in which configuration of trim packers/preload on coil overs, and rear spring height/rate to maximize ground clearance, level (remove rake), optimize ride, and maintain suspension geometry and driveline angles...
Goal: Eliminate brake dive,/body roll, improve trail ride/off-road performance/ trailering stability, Fit 34-35’s, increase ground clearance. Buffer/stabilize steering feedback.
Don’t want to create premature wear on CV’s or driveline, cv boots etc...
Build Plans: 3” lift, rear air leveling
(for trailering), Aluminum front bumper, skid plates, winch, rear locker, re-gear, + 2nd battery, +super cap+air compressor (under hood), electronic brake controller, ham radio, limo tint,
+magneson supercharger, + roof rack, +K&N Cold air intake, +full size spare, possible rear bumper w spare tire rack, recovery hooks/pull points, exhaust upgrade, OBD dashboard/heads up display, audio system upgrade, Mechman 320amp alternator, 16v regulator, full LED conversion, S-block-accessory switch module, light bar, ditch lights, work lights, fog lights, fridge, rear cargo storage system, remote start/alarm, front camera, black out/chrome delete, weather tech-hood protector, wind deflectors, floor liners, sound deadening, cb/vhf/ham radios. &more

 

I just placed my order for the Stage 3 kit.

https://trail4runner.com/2019/12/17/ironman-4x4-suspension-lift-kit-4runner-install/