Bilsteins @ 1.75 with .4 OME rear spacers?

Has anyone tried this set up? Got both on the way and was initially planning to run the bilsteins at .85 with the .4 spacers in the rear bc I like the rake but if this would give me a slight rake at 1.75 I might try that. Thanks for any incite.
-JD

 

You'll still get a slight rake with 1.75 F and 0.4 R.

 

I am going with 1.6 F and .75 R..........if my order ever shows up then I would know if it looks and rides good.

 

I did pretty similar setup using Eibach Pro-Truck Sport Shocks...they adjust using perch's just like the Bilsteins. Slightly different, but close enough where the info should be helpful...I think you'll definitely still have visual rake.

I set the front's to the 1.6" setting on the Eibachs and used a ¾" Cornfed spacer in the rear. What's funny is I had ordered the OME 10MM "trim packer" from ToyTec to use instead of the Cornfed, but changed my mind last minute. The trucks still got a considerable amount of rake to it on level ground...in retrospect I wish I had just kept the OME 10MM spacers.

I just received my Dobinsons c59-300 order for the front. Going to lower the Eibach perch's to "zero" and swap out the stock spring, while retaining the Cornfed lift in the back.

 

"I think you'll definitely still have visual rake"

That is my hope, I think the 4runner looks better with a little rake.

 

You got a side pic by chance?

 

This is the best I have at the moment.

 

That looks great, thanks

 

You running 265s or are they 275s??

 

275/70/17 KO2's

 

Perfect