1. Welcome to 4Runners.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all 4Runner discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other 4Runner owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

1988 4 Runner 3.0 auto to manual swap

Discussion in '1st Gen 4Runners (1984-1989)' started by Aceyjsony, Jul 3, 2024.

  1. Jul 3, 2024 at 12:26 PM
    #1
    Aceyjsony

    #1
    Aceyjsony [OP] New Member

    Joined:
    Jul 3, 2024
    Member:
    #41414
    Messages:
    1
    Gender:
    Male
    First Name:
    Jason
    Vehicle:
    1988 Toyota 4Runner 3.0 manual transmission
    Hello, I’m new to this community and I need some help. I have a 1988 4Runner 3.0 and just completed an Automatic to manual swap.
    In the automatic, below the radio, and behind the gearshift, there is a gray box called automatic transmission control.
    My question is, quotations. Is there anything that goes in this spot for the manual transmission?
    On the wiring harness that runs through the dash, the wire that goes to the automatic transmission control is different on the manual harness. And I am trying to determine what this plugs into. I have submitted photos of the automatic transmission control, and the terminal of the wiring harness from the manual transmission. Any help would be greatly appreciated.

    IMG_3302.jpg
    IMG_3303.jpg
     
    Aceyjsony, Jul 3, 2024
    #1
Register FREE to Reply!
To Top