Fumoto Clearance

Thinking of going the Fumoto valve way for oil changes. Anyone know if the

$36 F133S with LC-10 S-Series Large Body FUMOTO® Valve with Short Nipple and LC-10 Lever Clip for 12mm-1.25

F133S version with the short (or long) nipple interferes with the metal access panel? 2024 ORP

 

So that's what your nipples look like. We've always wondered!

 

Plenty of room! Have it on my '23 SR5P.

 

I think somewhere on this board it’s been confirmed that the F133N version of the Fumoto valve, with the longer nipple, fits without issues. I’m not sure I’d trust that short nipple on the

$36 F133S with LC-10 S-Series Large Body FUMOTO® Valve with Short Nipple and LC-10 Lever Clip for 12mm-1.25

F133S valve to hold on to a piece of tubing.

 

Hard as a brass fitting and leaking oil.

 

Mine with their removable plastic fitting for 3/8 tubing. Wasn’t sure if the long nipple would fit.

 

Go with the longer one. It would make things much easier. Still plenty of room.

 

do you have the long one installed on yours?

 

Not on mine. I have the short ones in the taco and the 4R. The short ones makes it a bit difficult to attach a hose or the other pieces shown above. That's all.

 

I have the long nipple with RCI skid, it does not stick out past the hole opening

 

same valve and skid plate on mine, long nipple is above plate.

 

Do you use one of the white plastic pieces (either the straight one or the 90* one) that snap on to the short nipple and that the hose attaches to, or do you just attach the hose directly on the short nipple?

 

I have the long nipple installed. There's plenty of room.