Dirt designs trailing arm 3link

Hey guys I’m selling my rear suspension setup. These trailing arms are BEEFY and never been installed.

These are made by steve at dirtdesigns. I believe he only had a few kits made. This one i asked him to make it adjustable and can extend the trailing arms from stock length up to +2 5/8” longer to push the axle back. With stock length you can achieve 16” of travel depending on tire size. More droop if you set up the arms longer than stock spec.


These are setup with coilovers and bypasses in the BACK! Lots of adjustability!

4runner Rear Link Kit
The kit uses factory front link frame mounts, factory axle, and factory fuel tank. It is designed to use King 8" coilovers and 10" bypasses to get 16" wheel travel. You do need to weld parts to your axle and frame so this is not a bolt on kit. We recommend using 2" wheel spacers with the factory axle or having an axle built that is 2"-3" wider than stock. There have been a lot of people with our Tacoma link kits running 2" wheels spacers and I have not heard of any issues.
No modifications needed for driveshaft(unless you push the axles back)

Complete kit. Trailing arms, 1x upper link, 1x trackbar, all link mounts required, shock mounts, heims, unis, and hardware.

Shock info is for King shocks and you can send this info exactly how its written and they should know what it all means.
C/O: 2.5x8, Over the top cap, 90deg fitting out of the top cap, raised spring plates, valving F12/08. Spring rate 450 lb
Byp: 2.5x10, 2 or 3 tube will work, something like style 2 or 3 will work. With 3 tube I think 15/10 valving. With 2 tube you might want 12/10


You can also run a 3.0 bypass. Just get the right placement for the tubes.


Asking $5,000

 

You should post this in the 4th gen section also. I've been wanting that kit for years, but I can't swing it right now.