Daytonaviolet’s Blizzard Pearl Build

I used the oem clips but changed the two upper ones with these. It’s very solid.

Rexka 30 pcs Switch Bezel Clip... https://www.amazon.com/dp/B07H87N1ZF?ref=ppx_pop_mob_ap_share

 

Well prior to the t12, I had the t9. You loose oem computer which holds oil change info. But you can just write those down.

I had a front CTH anytime camera and it look great on the big screen.

I opted for the redwood interior. It was my first choice.

 

Siccc what’s the difference between the OEM and rexka clips? T12 V2 is in my list.


Oh and if you even want to get rid of your Limited front bumper LMK I can pick it up whenever I’m in NorCal.

 

Rexka clips are thicker and creates more force.

sold my limited bumper 4 years ago

 

Looks good . But why post on my build thread

 

My bad, I went to the last thread I saw in my emails. I'll delete bud.

 

Deleted

 

No harm done. I just think your rig deserves its own build thread

 

Added the wireless seat adjustment module. Makes changing the passenger seat an ease.


https://www.instagram.com/reel/DEJHP5uSGNW/?igsh=NTc4MTIwNjQ2YQ==

https://cartrimhome.com/Wireless-Seat-Adjustment-Module-Power-Seat-Switch-For-Toyota-4runner

 

Nice - mine arrived last week. Have yet to install. Was it a pretty easy install?

 

Simple but the hardest part was removing/installing the seat side cover. The best way to remove them is where they meet.. push one side down and the other side up. This will make them open right up. Do the opposite when closing it up.

 

where did you order the color match handles from? Thx

 

Yes - that is what I was afraid of. Thanks for the tip! I will try it tomorrow! I think I am not going to attach the remote to the seat bolster, but rather keep it in my armrest for when I need it. I wont use it that often... just after I finish surfing and take the board out of the car (I push it through the rear window and have it rest on the headrest). But I always seem to forget to adjust the seat back up normally, so this will help without having to stretch over the entire inside and blow my back out.

 

yea some folks also leave it in the glove box. i stuck mine on as my son and others always set it too far back and makes it hard for folks in the 2nd row

 

Installed yesterday. Went pretty smooth but I think inbrikempqrt of the white pointed clip goes through the side seat hole
Plastic seems to be holding tight for now so I won't worry about it until it's a problem. Did you use any of the zip ties inside? Seemed to hold pretty secure without anything.

 

I used one tie wrap to hold the wires in place when then side cover was off. Not sure what is a inbrikempqrt

 

Ooops. Should have proofread. * I think I may have e broke off part of the white pointed clip that goes through the hole.

I didn't use any wire ties. Think I should re-open and secure it down at least with 1? Now that I broke off part of the clip, shouldn't be too big of a deal.

Thanks!

 

looks like a common clip you can find on a door card. But I don’t think it’s criticalz