1. Welcome to 4Runners.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all 4Runner discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other 4Runner owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

need help) won't return to cetner/ squeaking noise

Discussion in '3rd Gen 4Runners (1996-2002)' started by dominopizza, May 16, 2018.

  1. May 16, 2018 at 6:25 PM
    #1
    dominopizza

    #1
    dominopizza [OP] New Member

    Joined:
    May 16, 2018
    Member:
    #6044
    Messages:
    1
    Gender:
    Male
    First Name:
    Cast
    Vehicle:
    2000 4runner limited
    Hello guys I need some help here.

    I've already read the forums about the car not returning to center.

    to make it short, here's parts that i've replaced this year.

    front struts, inner and outer tie rods, upper and lower ball joints, front rotors and brake pads and rear shocks.

    after all these replacements, I didn't hear any squeaking noise but front struts are not OEM so it raised the front of the vehicle about 1~2 inches. (rear shocks are same height as the OEM). but recently i've changed my tires and I start to hear creaking noise from the front and my dad just came over and drove the car and told me car won't return to center.

    idk, if it's MR.tire guys mess up my car or i just need to get an alignment or something else is failing. any suggestions?
     
    Last edited: May 20, 2018
    dominopizza, May 16, 2018
    #1
Register FREE to Reply!
To Top