What have you done to your 5th Gen 4Runner today?

Very close to 1000...

 

With cold weather around the corner and after struggling last winter to raise the heat from the storage compartment into the sleeping cabin, I moved the heater to the sleeping cabin. Much better and a lot more efficient. While in single bed mode, the heater worked best, heating both upper and lower areas, it was difficult to get the heat into the sleeping compartment while in full bed mode.



At first, I tried spinning the heater 180 and venting it through ducting but the heater fan could not move the heat fast enough and the heat accumulated in front of the heater causing it to shut down due to overheating. Putting another fan at the distal end of the duct was another addition not interested in doing. Not to mention, that's how I raised the heat previously. While doable it was additional steps.



In the top storage, the heater fits perfectly without the heater's box heating up at all. In this location, it took no time to heat up the sleeping cabin. Thus, using less battery.



...and since now I travel mostly with India, The Bed Hog, the single bed is no longer a choice. Sacrifices.

 

1001! Just subscribed!!!

 

Before buying my 4Runner I read several posts and saw vids about the hood scoop causing glare and people getting decals to get rid of the glare. I thought this was silliness

now that I’ve had my 4Runner for 10 sweet months I’ve noticed the glare. While not horrible it is kinda nice to not have it so got a Hood Scoop Anti-Glare decal, Very civilized and helps as I usually have a 40-90 minute commute in mornings driving East with the glare in my face whole way and same on way home. ETSY also seems to have some good selection of those as well. Amazon associate link https://amzn.to/3FIPdoj

I would probably put the hood scoop anti glare decal as one of my first 5 upgrades. Not sure if the non hood scoop hoods give glare.

 

Scheduled 3M Ceramic front window tinting for Monday.

 

I had the same thoughts and I'm glad I did it. It's one of those few mods that is 1. relatively inexpensive; 2. functional; and 3. it looks really cool in my opinion!
I got mine from an Etsy seller and happy with it for sure. Mine also came with a TRD decal to put on the scoop and it looks really nice and OEM, too. Only issue I had with install was I have hood PPF and had to trim the "fingers" of my decal so it did not overlap the PPF.

 

Oh yeah I had to do mine also!! Nice.

 

Here's my previous TRD OR No Price yet. No pictures either.
https://www.bennetttoyotapa.com/used-Allentown-2018-Toyota-4Runner-TRD+Off+Road-JTEBU5JR9J5556864

 

Bought this awesome hoodie and added my first patch from 4Runner Lifestyle. Someone forgot to tell me that after you buy a 4Runner you are going to be buying a lot of other things for this religion. Also, added a back seat cover, it’s kinda marketed for dog owners I guess, but I just wanted a good seat cover that wasn’t so permanent — my back cargo mats are velcroed onto the back of the seats so I found this option to be great, I like that it’s easily removable for vacuuming and things like that. The center zips down so you can use the center cup holders. I still don’t have it completely fastened in tight or correctly yet but I’ll get to that.

 

I need to stay off this thread. I keep finding new ways to spend my money.

 

Yeah with the covers on, my Velcro seatback mats no longer have anything to stick to. It's no biggie but I could have saved a couple bucks and only bought the cargo mat.

 

Might not count as "doing something to the 4r" but:



I needed a new grill and Front Runner was having a sale, bad combo.

 

Believe me once you're on here you can't stop!! I had my 2018 the way I wanted it, now starting all over again

 

I’m most likely trading my 4Runner in for a 2025 so not getting too crazy on the upgrades and mods but if the 2025 is my 10 year 100k plus car I’ll definitely being personalizing the hell out of it. SR5 or Limited.

Tires and wheels most likely first thing to get upgraded. Then Window UV block/Tint, PPF

 

I did a search Brite Box has the harness, gonna go W/that & the small blue switch.

 

How much noise does that setup make? I get annoyed by the minimal noises of a stock rig, can't imagine what something like this sounds like on the open road or trail.

 

Finally pre-installed the Shrockworks Rock Sliders. Going to see how the wife likes them before pulling then off to clean me texture them. She's very indecisive so before I put the leg work in I told her to do a trial run. Finished in the dark so I will get more pictures.

 

Today I once again replaced the front diff (Valvoline 75w-90), transfer case (Ravenol 75w, hose included inside bottle!) and Toyota ATF drain and fill fluids. All went well. Last thing until 180K (minus oil) is the prop shaft greasing.

 

Set the T4R clock back an hour and cleaned the interior.

 

Oh shit, I forgot about this! Thanks for the reminder.

 

Pulled a cubic yard of rock on Friday. Turns out that little trailer is only rated for 2k lbs, so I am glad I didn't try for 2 cubic yards (1cb yd weighs ~2500lbs). It pulled just fine but I don't think I would try to get close to 5k lbs

 

Yesterday I went to Byrd's Adventure Center in Ozark, AR. Had some fun there and then went on some trails in the Ozark-St. Francis national forest. Then stopped at this super popular cafe. I just ripped this picture from google, but it was packed with motorcycles, sxs, atvs, and 4x4s. 1 hour wait for food!4runner did just fine, but I stuck to beginner/moderate stuff. Plenty of sxs only trails around here. Gonna need rock sliders soon, I scrape on those predator steps all the time

 

Not much of an accessory but figured I would throw this decal/emblem on the dash piece

 

Installed Toyota Rock Rails

still looking for suggestions for a solid shop to work with in the PDX area-I am looking to go with a mild lift. My Rig has KDSS and that needs to be kept operational.

I did speak with one shop about which system, height etc., and their first comment was to disconnect/cap off the KDSSSsystem and then lift...so scratch one shop off!

 

38 psi and adjusting the shocks for comfort helped my mpg. 17 mpg after 30 miles of combined driving. Not too bad with 34 inch tires and a lot of crap on the roofrack

 

Thank you very much.
Just created a little video thanking everyone and also I bet this would be a valuable "how to" video.

How to reset maintenance reminder for 4runner with key fob-
https://youtu.be/MAP4u2uk3CY


Also my old video,
How to reset maintenance reminder for 4runner with smart key (non keyfob models)-
https://youtu.be/8dwdx9lmv68

 

Today I plasti dipped all the chrome emblems. Rain made it dificult but I think it turned out ok. Cheaper than the sick ontop ones.

 

Mounted my ProClip mount + magsafe holder. Love the placement (hate too many screens/lights in my line of sight). Surprisingly holds my iPhone 15 Pro Max securely and attached/detaches easily.









Will finish wiring up and conceal white Apple cable with some black gaffers tape as soon as my USB-C to USB adapter comes in.

 

Got DS/PAX windows 3mIR tinted. Gonna order the Brite Box Anytime Fog/Driving light W/Small Blue switch. Added some faux CF too.