22" whees specks will these poke a bit

Want to get the following wheels for my 4 Runner. The specs are listed, would these stick out a bit or be flush with fender. Need some feedback from the wheel pros as to if they will fit.

Center bore seems off but isn't it what heliocentric rings are for?

• Wheel Diameter: 22 in.
• Wheel Width: 9.5 in.
• Wheel Size: 9.5x22
• Bolt Pattern 1: 6x139.7
• Offset: 15
• Center Bore: 112.1
• Wheel Load: 2450
• Wheel Color: Graphite
• Wheel Finish: Matte
• Wheel Material: Aluminum
• Aluminum
• Backspacing: 5.84

 

Don’t think a 9.5 wide wheel would poke at all with a 15 positive offset

 

I prefer spinners on my 22s for 4Runner.

 

Not a fan of spinner but to each is own.

I am more going for this look but can't get and answer from them. Not sure if the offset in the picture is 15:

 

4Runner uses hubcentric wheels (not lug centric). You need the correct hub or at least the adapter. You may need to be more worried about inner clearance for front UCA.

 

Thansk for teh feedback.

From reading around our OEM wheels have a bore of 106.1 mm, which means I would need to get hubcentric rings to fit between our 106.1mm and the 112.1mm of the aftermarket wheel.

You think the 9.5 with would go too deep into the wheel well and hit the front UCA? The stock is 7" wide this is 2.5" wider but seems to have same offset as OEM wheel. Does that mean it will go 1.25" deeper into the wheel well, and 1.25" to the outside?

 

Any wheel and tire experts that can chime in if these will fit?

 

Plug in your wheel and tire numbers.

Did you go to the wheel manufacturer's site? They only have one 22" wheel that is 6x139.7.
If it fits the runner in the picture then it'll fit yours.

Gotta do your own research for your specific wheel cause not much dubs on this forum.

 

Spinners on 26's fits more into the ethos of the 4runner I think.

 

Double check, but I don’t think your OE lugs will work. Judging by the picture you’ll need conical lugs.

If you go that route, post pics!