What have you done to your 5th Gen 4Runner today?

Thanks Jovany, no scratches where the bottom touches the paint?

 

None that I can see

 

Thanks. Looking forward to getting ours. Did you have to change the gas struts on the liftgate?

 

Yea I did

 

Good to know thanks.

 

Replaced the silver trim on the front with this BADASS @Relentless Lo-Pro Stingray bumper. Eric's designs continue to amaze me!

 

WOW. She is fantastic.

 

How's the install on that?

 

A lot easier than some may think. A little work for a huge change in my opinion is a no brainer! We removed the front bumper, unbolted/ un clipped the lower grille piece, cut the center piece out and bolted in all the new pieces. That's the basic run down of it.

 

So you did have to cut the bumper?

 

Yes you need to cut the plastic, which is common with most bumpers like this one.

 

Right on

 

How was the process to get the emblem and the 4 runner letters painted black? Please advise.

 

Put on NFABS. Not exactly what I wanted but the kids and wife needed a step.

 

Super easy. Tape off area. Spray Plasti-dip over entire area. Peal off Plasti-dip from paint, it stays on the emblems. Step by step process in link below.

http://www.clublexus.com/forums/is-...p-no-emblem-removal-required.html#post5816370

 

Thank you very much. Will give it a shot

 

Those bars look great and functional too. You have a sweet Rig.

 

Got another set of 2016 Trail wheels for mounting AT tires on. I should have the set this Friday.

For tire size I'm thinking either stock (265/70/17) or is there a 270?... on stock suspension. What do you guys think?

For tire brand and model, I'm thinking one of these: BFG

$331+ BFGoodrich All-Terrain T/A KO2 Tires

KO2 /

$216+ Firestone Destination A/T Tires

Firestone Destination A/T / General Grabber AT 2.

Lots to research before wheels arrive.

 

275/70/17 is the next size up. They are kind of a rare size and usually only come in load range E for the most part.

 

295/70/17 Toyo Open Country R/T's & ARB Dual Air Compressor

 

That is a beautiful ride. Great job.

 

I installed these this morning... NFAB step rails....

 

Great job. Very useful as well.

 

Did you install the compressor yourself?

 

Had my steps installed today. Found a great place in Pasadena TX that installed them for cheap.

 

Nice rig. You will enjoy that for years.

 

trying to sell mine...

 

Why are you selling and how much are you asking?

 

Because I don't drive it. It just sits in my garage. It's never even been offroad. kinda sad

asking $35,500. It's a 14 trail premium with KDSS. 40K miles. Toytec BOSS suspension. Brand new 285 Nitto G2s.

 

That's a fair price for a great rig. I will pass it around. Good luck.