'21 TRD Pro light bar wiring?

Has anyone successfully installed an LED light bar/pods into a 2021 TRD Pro using high beams as the activation?

I have a set of Baja Squadron fog lights from my old Tacoma. I purchased a Rago light bar mount and Baja Designs wiring harness with relay and switch.

I was able to find a 20A fuse under the hood that disables the stock LED high beams. When I plug the add-a-fuse in, the fog lights turn on even with the vehicle turned off. Using a volt meter I found that the only fuses under the hood not getting constant power are the low beams (which doesn't help me). There are two 10A low beam fuses and 1 20A high beam.

Can anyone point me in the right direction? I had no problem with a similar setup on my Tacoma which obviously had different wiring. There is not alot of info out there for the new led lo/hi beam wiring. The digram under the fuse box lid even has several discrepancies which make things even more difficult.

 

This is probably going to be less than helpful answer BUT, I know this is possible at least on the 16's as this is how my roof light are activated, by the high beam stalk.

So its a thing, just couldn't tell you how as I paid a shop a bunch of money to do all the wiring haha

 

I called Baja Designs and they were as helpful as they could be given there is not much info available on the '21's. It seems to be something that is doable but the only info they were getting was from previous model years and the new ones seem to be quite a bit different.

 

Hell, if we could do that, maybe we could actually get the 9005 high beam to work too!! That's what I have been trying to figure out!

 

Welcome