1. Welcome to 4Runners.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all 4Runner discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other 4Runner owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Package tray R&R

Discussion in '5th Gen 4Runners (2010-2024)' started by Sandbuster, May 5, 2021.

  1. May 5, 2021 at 7:49 AM
    #1
    Sandbuster

    Sandbuster [OP] Breaking Wind

    Joined:
    Jan 16, 2021
    Member:
    #19157
    Messages:
    696
    Gender:
    Male
    First Name:
    Mike
    Central Florida
    Vehicle:
    2019 TRD Offroad
    Power Commander, LED lights upgrade, Eibach Pro Truck Series suspension upgrade (front & rear), Airbags (rear), dash integrated trailer brake control, Body Armor front bumper, Smittybilt 10K winch
    1. I'm trying to remove the little cargo area (interior) package tray above the right rear wheel well - seems like it's trying to come out but resisting to the point of breakage. Do I just "man it out" or am I missing something here?

    2. Same question regarding the power center in the same panel - will it snap out or just snap in half?

    Vehicle is a 2019 TRD Off Road.

    Thanks for your help!

    Sandbuster
     
  2. May 9, 2021 at 6:22 PM
    #2
    Sandbuster

    Sandbuster [OP] Breaking Wind

    Joined:
    Jan 16, 2021
    Member:
    #19157
    Messages:
    696
    Gender:
    Male
    First Name:
    Mike
    Central Florida
    Vehicle:
    2019 TRD Offroad
    Power Commander, LED lights upgrade, Eibach Pro Truck Series suspension upgrade (front & rear), Airbags (rear), dash integrated trailer brake control, Body Armor front bumper, Smittybilt 10K winch
    Yup - I just "man-handled" it - broke the screw tabs and off it came. Also to note, to remove (successfully) the cargo area power center, lift up from the bottom, NOT the top as it has two solid J-hook tabs holding it in place. Pry up from the bottom, pull down, and it will come right out. I added a constant voltage 12 volt receptacle just below the OEM pwr center. I used a wire chase to pull cabling through the fender panel without having to remove anything other than the package tray.
     
    grizzlypath and MeefZah like this.

Products Discussed in

To Top