What have you done to your 5th Gen 4Runner today?

Def the dual. It’s significantly faster than the single, and also 100% duty cycle; never needs cool downs in between tire fills. I used to have the dual with a 2 gallon tank in my jeep; even ran air tools off of it on the trail. Would someday like that setup again in my 4Runner (just using a viair portable at the moment; it’s tolerable, but way slower than what I was used to).

 

Last night actually windows tinted .....

 

[QUOTE="GRIZ, post: 206484, member: 14426"

Anyway, something to fill the mod bug ordered the puddle light switch from meso,




[/QUOTE]
Still curious what 12v power source you tapped for the switch illumination. Should be doing the install in a day or two. Once I can stay vertical for more then 20 minutes (stupid Kung Flu).

 

Cleaned off the salt.. First oil

 

Took Dashboard apart.. Scary! Remote starter installed..

 

Congratulations!
What brand did you buy? We have a 12volt.Solutions awaiting install.

 

Went with Acessorides kit.. plug and play for '21.

 

Finally got around to installing my Eibach lift and Ironman uca’s and spidertrax spacers.

 

Dang..!! That look soo good. Looks taller than 3 inches.

 

Any issues with the spacers

 

Broked it bad.

 

That is one good looking 4Runner!

 

Just screwing off. Had a really really shitty day at work. Am now not working for 14 days while my office is being disinfected and made COVID free.

but tonight’s project

 

Looks tough!

 

No, it's molded to wrap over the hood. It has openings so water drains out. From what I've seen and read the AVS is one and the same as weathertech, although I've not seen it in person.

 

That looks awesome! now the magic question... does the safety sensor act up with that? what bumper is that?

 

Not yet but the jury is out I only drove it a little bit. It’s the warn bumper and is supposed to work for 2020’s but again we will see. If it does I think someone mentioned angling the sensor down which I looked at the back of the bumper while I had it off and I can see it’s not hard to do so and to even move it down a little if you’re really good with a dremel

 

Keep us posted! I like the look. Can you post a pic straight on at the height of the top the bull bar and a side shot? thanks

 

I Installed a Victory 4x4 Roof rack the other day. I think it looks cool.

 

I will get some tomorrow I need to get it cleaned up. And finish hooking up the winch and figure out where the crap I’m going to mount this cut off box

 

Looks great! …
Purchased this Warn Bumper last year for about $550 during a 4Wheel Jeep Show here in Nashvile and have yet to install … was waiting on winch purchase …

Question: Did you have much room to install the winch you have and did you have to adjust any of the AC Lines in front of the radiator?

 

Nope, everything fit perfect with plenty of room to spare. I was initially concerned about that because the winch bolts as far back as it possibly could in the bumper and I just knew that without relocating the control box it was going to hit. I’m very please to say it does not. There’s room back there for days.

 

That’s great to hear and Thanks for sharing!

 

No worries.

 

No, not at all

 

Got the meso puddle lights and switch installed, along with my Chinese sequential indicators for the mirrors.

 

Experimented with some vinyl wrap