1. Welcome to 4Runners.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all 4Runner discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other 4Runner owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Ignition Switch Problem

Discussion in '3rd Gen 4Runners (1996-2002)' started by baggerjohn, May 17, 2015.

  1. May 17, 2015 at 8:43 AM
    #1
    baggerjohn

    baggerjohn [OP] New Member

    Joined:
    May 17, 2015
    Member:
    #611
    Messages:
    5
    Gender:
    Male
    First Name:
    John
    Vehicle:
    96 4runner
    none
    I have a problem with my ignition not releasing my key. I changed out the ignition cylinder but that didn't fix the problem. The only way I could get the key to release was to disconnect the battery. I then went on to replace the ignition switch. After installing the switch, I cannot get the cylinder to install. I would appreciate any help as I'm dead in the water. Thank you in advance.
     
  2. May 18, 2015 at 3:57 PM
    #2
    Utah

    Utah Misanthrope

    Joined:
    Jul 31, 2014
    Member:
    #213
    Messages:
    194
    First Name:
    Kevin
    Land of Fake Beer
    Vehicle:
    The Gray Bastard
    3RZ, OME, 5.29s, 4.7, locked/locked
    Automatic? There's a shift interlock switch that might be bad.
     

Products Discussed in

To Top