1. Welcome to 4Runners.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all 4Runner discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other 4Runner owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Brake job problem

Discussion in '3rd Gen 4Runners (1996-2002)' started by Jgriff189, Dec 28, 2019.

  1. Dec 28, 2019 at 5:29 PM
    #1
    Jgriff189

    Jgriff189 [OP] New Member

    Joined:
    Dec 28, 2019
    Member:
    #12491
    Messages:
    3
    Gender:
    Male
    Replaced both front rotor and pads, no problem on driver side. On the passenger side the outer brake pad is hitting the rotor causing the pins not to fit in. The old rotor/pads also will not fit anymore.... have no idea what could have happened. Iv tried putting the pads on the caliper then mounting the caliper, and mounting the caliper then pads. And the outer pad will always contact the front of the rotor. It's a 1999 4runner 4x4 with the v6. Any ideas?
     
  2. Dec 28, 2019 at 5:43 PM
    #2
    SlvrSlug

    SlvrSlug Slightly bent.

    Joined:
    Jun 3, 2018
    Member:
    #6172
    Messages:
    7,859
    Gender:
    Male
    First Name:
    John
    Ramona Ca.
    Vehicle:
    2017 4-Runner SR-5 P. Kings, Built Right uca’s, Durabumps, RSG sliders
    Welcome to the forum, i believe some of the 3rd gens. Had the bigger brakes. Maybe someone else has a little better info.
     
  3. Dec 28, 2019 at 5:47 PM
    #3
    Jgriff189

    Jgriff189 [OP] New Member

    Joined:
    Dec 28, 2019
    Member:
    #12491
    Messages:
    3
    Gender:
    Male
    They are disk brakes, two sets of pistons per brake if that helps any
     
  4. Dec 29, 2019 at 1:10 PM
    #4
    Jgriff189

    Jgriff189 [OP] New Member

    Joined:
    Dec 28, 2019
    Member:
    #12491
    Messages:
    3
    Gender:
    Male
    I'm an idiot. The outside and inside pads are different...and I was trying to put two outside pads on the passenger side. Problem fixed! Now to figure out where I'm leaking so much oil from...
     
    Tama1968 likes this.
  5. Dec 29, 2019 at 1:20 PM
    #5
    Tama1968

    Tama1968 New Member

    Joined:
    Jan 2, 2016
    Member:
    #1353
    Messages:
    711
    Gender:
    Male
    Florida
    Vehicle:
    T4R SR5 in Classic Silver
    I've been there, buddy. good luck with the oil leak
     

Products Discussed in

To Top