What have you done to your 5th Gen 4Runner today?

You should try it, I've been miserably, I mean happily, married for almost 38 years.

 

WOW,
what did the rotor look like?
I see signs of alot of heat.

 

Change that caliper soon.

 

Here, let me fix that for you…..

 

there you go

 

Damn!!

 

Drove her to the donut shop this morning

 

nice! Can you post trans temp code you used?

 

I didnt see anything. Deny deny deny

 

my trail special doesnt have any badges. :-(

 

caliper sticking?

 

Great color. I wanted Terra, the wife wanted white, so we compromised.

 

Installed some AJT designs climate control knobs and a TRD Pro roof rack.

 

thanks!

 

Sitting at Discount getting the tires rotated and balanced. Car wash after. Pollen has started. Yuck.

 

Hope aftermarket skids have enough air flow after you remove the factory air duct.

 

A bit difficult to see in this pic, but there's a small gap between my bumper and skids, plus obviously openings in the front of the engine skid to allow air flow. So far I've had no issues at all.

 

Unlike other trims 4Runner Limited have low hanging bumper almost below the vent holes of the engine skid. So there is air duct work taking air from the lower grill (the opening between the bumper and black color piece).

 

Changed all the brakes and rotors on the wife's cx5 too. Definitely felt it after that!

 

There's 4 options listed on Scangauge site.........standby and I'll get 'er posted up...........

 

Old girl got her first tattoo. Probably a 10hp gain at least

 

Finally got rid of all the chrome ! At least as much as I am willing to do.
It was unnecessarily time consuming, expensive and cumbersome.
Door handles, Side Steps, chrome trim front, rear and sides, roof rails and end covers , wheel caps, rims, tail lights, tailgate piece, front grill, signs and logos, fog lights brackets etc etc etc.

 

What about those lug nuts?

 

Thankfully, they don't bother me.

 

I used the black vinyl lug nut covers for mine. The actual black lug nuts were on back order and they’re expensive.

 

The chrome in those tail light is blinding me.

 

Thankfully, don't notice, don't care.

 

Sorry for the delay......grand-daughter came over to do some art work with grandpa in the coloring book!

So, Scangauge gives 4 possible codes for the tranny fluid temp.....the video I watched showed #3 on the list........figured I'd try it and if it didn't work I'd go to another. It worked........here's the settings below..................

TXD 07E02182

RXF 046105820000

RXD 2808

MTH 00090005FFD8

Hope this helps you and others!

My '23 is an SR5P.....don't know if that matters or not!

 

Ho-ly!
I gotta learn those still