Morimoto Headlight install

Hey all, I'm installing Morimoto XB EVO Hybrids on a 2020 4R. If I use the INJ fuse slot as recommended, the fusebox cover will not close because that row of fuses is raised. The other 10A circuits are either controlled by the headlight switch or are constant power. Has anyone else run into this?

 

https://minwin3d.com/products/engin...WtE_wiv-2i9efT3F2ptf5MId5tarOVIm2n73QP6Z9of6q

 

Welcome. Correct. I notched out part of the edge. They make solutions you can buy.

 

Yep, had this exact issue. I ended up not fully latching the front left tab. You could run the wire into the cabin fuse box (I'm not sure if 2020s have this actually).

Also, $75 seems excessive for a piece of 3d printed plastic

 

I notched my lid, not the box for my install. Since I have a 19, the Minwin riser is not an option but here is working on them for the earlier models. I'll get it and a new lid so it's a cleaner install. Personally I would get the riser to make it clean.

 

I'm not sure why Toyota changed their fuse box design, but safest and cleanest bet would be to just run it into the cabin fuse box for OP. I don't do water crossings or drive fast through puddles, so I'm not super concerned about moisture

 

The Morimoto harness has a grommet already on it so it isn't so open to the elements. They even include a harness to run it into the cab with a firewall grommet on it as well but I needed it for the passenger side DRL wiring because the harness wasn't long enough.

 

heated the lid with a torch and pushed it out a bit