Toyota Funner build

I bought my 4Runner new in May 2017. Mods so far as of December 2018...

Bilstein 5100's front and rear. Front set at max height, with Wheelers Off-road 1/4 inch spacer in front, and Daystar 1 1/2 inch spacer in rear. Lift gave approximately 2 7/8 inch lift in front, and 1 1/2 inch in rear. I did buy a diff drop kit, but did not install as they seem to be mostly useless on 5th Gens. Stock UCA's. Toyota aligned front end, and was able to get it just slightly out on Camber and Caster with Toe in specs.

ARB Rear Locker RD193, ARB on-board air CKMA12. Used "Air On-Board" OEM style switches to give it a factory look in the cab.

TRD Off-road Wheels 17x7.5 with BFG KO2 AT LT285/70R17 Load range E "DT". Had to trim a little off front and push forward the fender liner. Did not have to remove mud flaps.

Raised rear axle vent to top of gas filler neck.

Yellow Fog light bulbs.

 

ARB RD193 Switches from Air Onboard The compressor mounted to a bracket from Slee Off-road.

 

Looks like a great build. We need more photos - OBA mounting location? OBA Switches? Different angles?

 

looks good

 

10-4. Added more photos. Thanks guys.

 

The only work I didn't do myself was setting up the 3rd member. I have done Detroit lockers and others before, but this is my first ARB and I let a guy who knows then do the work. I did R&R it myself though...

 

Nicely done. Clean, simple, cost effective and functional.