Anyone recognize this front bumper

Anyone recognize this front bumper?



I'm looking for a low profile winch mount bumper that has the following:
- a vertical fairlead mount.
- good access to the winch controls
- no stupid light bar cutout
- recovery points

This one meets all of these requirements...but I have no idea who makes it. Found it on an image search.

 

This bumper was made by Relentless Fabrication, and according to their website, they do not make it anymore:

https://www.relentlessfabrication.com/

 

Thanks.... and darn!

I also found one that DV8 used to make, that I really liked, but it also is no longer available.

My top contender so far is the Warn 100022, but I'm still searching the far corners of the interwebs.

 

I had this one on my Tacoma. I bet it would fit the 4Runner:

 

i love my SSO bumper

 

I think your list of wants for a bumper is reasonable (functional and attractive). A number of the places that sell these are fairly small operations and if you found one that was right except had light bar cutouts, have you thought about calling and asking if they might fab one for you without that cut out? You'd have to wait obviously, and maybe pay a slight premium, but I think most fab shops are waterjet or laser cutting these so leaving out a cut isn't too big of a request.

 

C4 also makes one. They were one I was looking at if I ever needed a bumper.

 

+1 vote for the c4 low pro

 

I have that bumper. It's been bashed on rocks and hit a deer at 55 mph. There is enough room to drill and tap for a license plate. A buddy had some expanded aluminum laying around and we made a grill to keep the rocks out of the radiator. Also made covers for the access holes to keep the winter slop out.

 

We will custom make it to fit your needs just hit us up

 

I like your bumper better than the SSO simply for the shackle mounts. Will your bull bar work with the front sensor/camera?

 

I have an SSO bumper that provides a clear view of the winch rope spool via the light bar cutout that is not used for a light bar and also has cutouts for access to the winch clutch handle. By “clocking” the winch clutch housing 90 degrees, it is easy to use through the cutouts.

Also, the hoop does not interfere with TSS…

Cheers,
Bob

 

Yes if noted with purchase I can do tss height bar. Either short or tall to go above it. I'll also be adjusting the shackle mounts toove the pin hole up higher for a more approach angle