CBI Rear Bumper w/Dual Swing-outs Install

We just received our new rear bumper from CBI and it looks wonderful! Ours is a dual swing-out with dual can holder, highlift mount, and fold down table (lots of bags of bolts, nuts, brackets, and assorted hardware). The fit, finish, and attention to detail is incredible. One detail they left out however are instructions on how it all goes together. Most of it is pretty simple to figure out but some, like the bearings and seal on the swing-out hinge, we're scratching our heads over.
After over an hour of searching and pouring through past threads we're still at a loss.
We found the pdf on their website showing how to bolt on the actual bumper but nothing more. We have an email into Nathan at CBI, I'm sure he'll get back to us with some answers. In the meantime we're looking for real-life experiences on the install and pics. Particularly of the cutline at the fenders, latch mount, attaching the highlift, etc. Also, options and suggestions on relocating the camera and license plate & light.
We'll be showcasing the setup in one of our upcoming install videos, hence the need for detailed and accurate information. Any help and/or photos you can share would be greatly appreciated.

 

Can't wait for another one of your great videos! Also glad to hear that both of you guys are okay after the accident and things are getting back to normal.

 

Here's the video of the install.
It all went extremely well!
We did have to redirect the tailpipe out the side, but that
was nothing a quick trip to the parts store to get a bend
couldn't solve.

https://youtu.be/4M_X6rKzdKA

 

Man looks awesome can wait to get one

 

Whats ur Insta?

 

https://www.instagram.com/wanderlost_overland/

 

I would think that it would be removed to improve departure angle, however after watching his video and the view from the ground up when under the rig, it almost looks like it is still there.... OP?

 

It comes off. The bumper has its own built in.

 

Thank you for the post. When you have time can you help me out with two measurements? 1) Can you tell me how far the furthest portion of the back tire sticks out from the back of the "n" in the "4Runner" logo when the dual swing arms are closed? 2) What is the distance from the back "n" to the furthest portion of dual swing arms when they are opened at 90 degrees to the bumper? Does the swing arm with tire stick out further than the hatch itself when it is being opened?

I'm adding onto my garage and want to make sure I have just enough room to get the dual swing arms opened and the hatch opened with the garage door closed.

Thank you for your time.

 

1) Can you tell me how far the furthest portion of the back tire sticks out from the back of the "n" in the "4Runner" logo when the dual swing arms are closed?
It was tough to get an accurate measurement off the emblem so I measured from the hatch at this point.

Came out to right around 21".

2) What is the distance from the back "n" to the furthest portion of dual swing arms when they are opened at 90 degrees to the bumper?
That would be the side of the spare. I measured from the tail light here;

Looks like 39.5".

The tire swing-out does come out further then the hatch.


Hope this helps.
The bumper has been holding up great! No complaints or concerns.