New Sus Lift & Tires

My stock tires were finally getting worn down so it was time to do my lift. I’m in no means an avid offroad-er and it will only see the trails a couple times a year so I went with the budget friendly lift recommended by 88 rotors in El Monte Ca.

bilstein shocks, ome coils, and spc upc
Fitted with falken wildpeak at3 285’s

88 rotors did an amazing job had me in and out in 2.5 hours

 

2.5hours? Are you serious? They have hired Flash?


Wonder if they will post your video. Looks very good..

Which Bilstein shocks did they use?
Was there any reason to change the wheels? They look really good though.
Did they use P285/70R17 or a different one (load C or E)?

 

Looks really good. I like it!

 

Looks like they posted it up!!

 

2.5 hrs.... I would be concerned what they didn't tighten.

 

88 Rotors did my lift, they are a well oiled machine. It’s pretty much all they do is install lifts. About 8 guys get on it and they have a system to verify each every bolt & but was tightened and torqued to manufacturers specs.

 

I was going to say, 88 rotors has done this for years, on a billion vehicles. They have it down to a science.


OP- that looks really really good mate. Happy adventures

 

Looks good

 

Looks great. Tasteful.

 

What a great stance.

 

Looks great!

 

Very Nice!

 

Load C, they used the 5100’s. No reason to change wheels just got the methods as a gift. Tires do have minimal rubbing right now that will hopefully go away after an alignment or might have to do some cutting. They had 6 guys come in like the minions!

 

That's pretty awesome. A minor trimming and pushing the fender liner would definitely help you to clear the tire offroad then its fully compressed. That might allow you to have the mud flap back. It is very hard to listen to the sound of rock chips and dirt hitting the sides then there is no mud flaps and running boards / sliders with top plate for me. Please share the video if 88Rotors publish yours.

 

I have a similar build on mine. What lift did you do as yours looks higher than mine. I did use toytec instead of OME. I did a 2inch front 1 inch rear

 

Looks great!

 

What rims are those?

 

88 Rotors is legit if anyone decides to doubt them. Nice setup. I'm sure they will post up your build on their YT channel.

 

They tag team it hence why they can do it so fast and they do literally thousands of toyotas as everyone said. They do great work, prices have went up but so has every other shop. Good dudes there

 

Method MR316. Gloss Titanium. Wasn’t 100 when i picked them but I think it came out good. Looks great against the metallic Grey paint.