I Cannot Express How Awesome Hefty Fabwork Sliders Are.

Fit high up, bolt on, non angled so do double duty as a side step without the necessary some others that need to angle up due to sitting lower.

turnaround time was a little under 6-7 weeks between time ordered and delivery and apparently now there is even a Labor Day sale. Awesome product. Just thought I’d share.

 

Could not be happier

 

NICE LOOKING RIG!

 

Jelly

 

They look great but man they're expensive, even with the $100 off

 

No argument there. But I just figured I'd rather buy once, we'll made and quality, rather than twice even if it's a little pricier than others. I will say though it's in par with a few other options I looked at

 

looks nice! my nFab ones are already showing surface rust after a month... might be looking around for something else in the near future

 

Got mine put on yesterday and they are solid!

 

Oh yeah and I would recommend you get some extra hands to help put them into place while putting on the bolts. A floor jack helps a ton too.

They are solid! Haha took me a little over 2 hours but I was taking my time.

 

Awesome bro, and sorry I never saw your message about them.

 

All good man. Got everything figured out. Thanks!

 

Did you end up using a thread chaser or tap for these? I have a set waiting in my garage for my 4Runner to finally arrive!

 

I actually did not have to. I ran a bolt thru a couple of the frame holes and when I took it out it looked pretty clean. So I just sprayed them with some wd40 and let them soak for a bit then installed the sliders with no issues.

it probably helps that the truck is pretty much new and hasn’t seen mud or dirt yet.

 

Thanks for the quick response! I plan to install mine on day 1 so I should be good too!

 

Yeah should be good. Make sure to remove this bolt from the gas tank skid on the drivers side before installing the driver side.

 

Thanks for the heads up!

 

Nice rig, best looking color.

 

Looks good. I frequently use my Shrockworks sliders off road.